Practice Free 300-120 Exam Online Questions
Which feature needs to be enabled for a Layer 2 device to listen in on IGMP membership reports that are sent by hosts?
- A . Internet Group Management Protocol (IGMP)
- B . IGMP snooping
- C . Protocol Independent Multicast (PIM)
- D . CAPWAP tunneling
When deploying higher throughput wireless technologies in Local mode, what design aspect must be considered related to possible oversubscription of the physical infrastructure?
- A . Uplink capabilities of the access switch should be considered.
- B . Physical connections between the access switch and AP should be considered.
- C . Performance of the backbone network connecting to the controller should be aligned with overall wireless performance demands.
- D . Performance capabilities of the controller should be considered.
- E . All of the above.
You are asked to provide an indication of the number of access points (APs) for a new office without going onsite.
What kind of survey best describes this type of estimation?
- A . Predictive site survey
- B . Layer 1 sweep
- C . Passive survey
- D . Proactive survey
Which channels does the 802.11 standard define for sending multicast frames so that all associated stations can receive them, regardless of what channel width is in use?
- A . 8 MHz
- B . 15 MHz
- C . 20 MHz
- D . 40 MHz
Which one of the following is a commonly used signal strength that defines the boundary of an AP cell?
- A . 20 dBm
- B . 67 dBm
- C . 0 dBm
- D . C20 dBm
- E . C67 dBm
Which of the following lists the Cisco Connected Mobile Experiences (CMX) trial license entitlements?
- A . Connect: 120 days for 100 access points
- B . Analytics: 120 days for 100 access points
- C . Locate and Detect: 120 days for 100 access points
- D . All of these
Which Cisco Spaces license tier typically includes Location Analytics capabilities?
- A . See
- B . Trial only
- C . Act
- D . None
Which of the following Cisco monitoring tools offers machine learning as part of network trend prediction?
- A . Cisco PI
- B . Cisco MSO
- C . Cisco PPDIOO
- D . Cisco Catalyst Center
An engineer is configuring a BYOD deployment strategy and prefers a single SSID model.
Which technology is required to accomplish this configuration?
- A . mobility service engine
- B . wireless control system
- C . identify service engine
- D . prime infrastructure
Refer to the exhibit.
An engineer is troubleshooting a client connectivity issue. The client is in the RUN state, and no traffic is passed after authenticating by using Cisco ISE.
Which action resolves the problem?
- A . Configure a different client VLAN after authentication.
- B . Disable the ACL that prevents traffic from being allowed.
- C . Apply a lower WMM QoS.
- D . Enable rate-limiting to the client.