Practice Free 300-120 Exam Online Questions
A networking associate notices icons resembling cameras on your Cisco Spaces site list.
What do these icons represent?
- A . Meraki cameras
- B . Locations that require the admin attention
- C . Places where coverage is insufficient
- D . Positions that were manually calibrated
Which feature needs to be enabled on every wireless LAN controller in order to leverage multicast in a mobility group?
- A . Multicast mode
- B . IGMP snooping
- C . Multicast messaging
- D . MLD snooping
Which feature keeps track of and delivers IPv6 multicast flows to the clients that request them?
- A . Internet Group Management Protocol (IGMP)
- B . Protocol Independent Multicast (PIM)
- C . IGMP snooping
- D . Multicast Listener Discovery (MLD)
Which technique uses received signal strength (RSS) to provide 802.11 location-based services?
- A . RSSI trilateration technique
- B . Cell of origin technique
- C . Signal-to-noise ratio technique
- D . Angle (angulation) technique
Refer to the exhibit.
An engineer is creating an ACL to restrict some traffic to the WLC CPU.
Which selection must be made from the direction drop-down list?
- A . It must be Inbound because traffic goes to the WLC.
- B . Packet direction has no significance; it is always Any.
- C . It must be Outbound because it is traffic that is generated from the WLC.
- D . To have the complete list of options, the CPU ACL must be created only by the CLI.
Which device location technique is also referred to as lateration?
- A . RSSI trilateration technique
- B . Cell of origin technique
- C . Signal-to-noise ratio technique
- D . Angle (angulation) technique
Which multicast IPv4 group address is used for sending Bonjour mDNS advertisements?
- A . 224.0.0.251
- B . 239.1.1.9
- C . 239.255.255.255
- D . 239.1.0.1
If RRM decides to change an AP’s transmit power level, which one of the following correctly identifies the action to be taken?
- A . The AP’s transmit power level will be changed immediately to the desired value the next time TPC runs.
- B . The AP’s transmit power level will be raised or lowered by one 3 dB increment as needed each time TPC runs.
- C . The AP’s transmit power level will be changed immediately to the desired value the next time DCA runs.
- D . The AP’s transmit power level will be raised or lowered by one 3 dB increment as needed each time DCA runs.