Practice Free HPE6-A89 Exam Online Questions
Which of the following statements is true about External BGP (eBGP) neighbors?
- A . They must reside in the same autonomous system
- B . They use UDP for updates
- C . They typically have a default TTL of 1 hop
- D . They require GRE tunnels to exchange routes
Which storage location is used by default when saving configuration files in Comware?
- A . /tftpboot
- B . flash:/
- C . boot:
- D . /var/tmp/
Scenario: You are configuring IRF between two Comware switches. You have bound the physical interfaces to IRF ports and connected them.
What is the next required step before IRF will operate properly?
- A . Configure loopback interfaces
- B . Enable VLAN 1
- C . Assign unique IRF member IDs and priorities
- D . Set STP mode to MSTP
What is the function of the PVID on a trunk port?
- A . Assigns default IP address
- B . Determines the VLAN for untagged frames
- C . Blocks tagged VLANs
- D . Enables STP on the VLAN
Which command applies an ACL to an interface in the inbound direction?
- A . acl apply in
- B . ip access-group in
- C . packet-filter <acl-id> inbound
- D . acl direction in
Scenario: Your customer wants to limit YouTube traffic to 2 Mbps on a specific uplink port but allow all other traffic without restriction.
What configuration approach should be used?
- A . Enable storm control
- B . Set global QoS policy for all interfaces
- C . Classify YouTube traffic by IP or port, and apply CAR rate-limit
- D . Change the PVID for the uplink port
What is the purpose of the dns domain command in Comware?
- A . Sets the default gateway
- B . Assigns a hostname to the switch
- C . Specifies the DNS suffix to be used during name resolution
- D . Configures NTP server
Which transport protocol does BGP use for establishing neighbor relationships?
- A . UDP
- B . TCP
- C . ICMP
- D . OSPF
Scenario: You’re configuring a Comware switch to act as a DHCP client on interface Vlan-interface 100 to receive an IP address automatically from a DHCP server.
Which command must be applied within the VLAN interface configuration?
- A . ip address dhcp
- B . ip address dhcp-allocate
- C . ip dhcp enable
- D . address-mode dynamic
Which command enables IP routing on a Comware switch?
- A . ip enable
- B . ip routing
- C . ip route enable
- D . routing