Practice Free HPE6-A86 Exam Online Questions
Which CX model allows for VSF?
- A . CX 10000 Series
- B . CX 6200M Series, and CX 6300 Series
- C . CX 6000 Series, CX 6100 Series, and CX 6200F Series
- D . CX 8100 Series and CX 8400 Series
A Support Technician is troubleshooting a problem where a new VoIP phone is not turning on when connected to port 1/1/10 of an AOS-CX switch. The technician needs to verify if the switch is providing Power over Ethernet (PoE) to the port and check its status.
show power-over-ethernet interface 1/1/10
Status and Counters – Port Power Status for port 1/1/10
Power Enable : Yes
PoE Port Status : Searching
…
Detection Status : Searching
Based on the output, what is the most likely issue?
- A . The switch has insufficient power in its PoE budget.
- B . The port is administratively disabled.
- C . The VoIP phone connected to the port is not a PoE-capable device or has failed.
- D . The port’s PoE priority is configured too low.
A Network Technician is configuring a new AOS-CX switch to enable it to route traffic between different VLANs. The switch has several VLANs with IP addresses (SVIs) already configured.
Which single command must be enabled in the global configuration context to activate the switch’s Layer 3 routing capabilities?
- A . `ip default-gateway`
- B . `router ospf 1`
- C . `ip routing`
- D . `enable`
Which port role in RSTP is responsible for forwarding traffic toward the root bridge?
- A . Root port
- B . Designated port
- C . Alternate port
- D . Edge port
What IP protocol number is associated with OSPF?
- A . 6
- B . 17
- C . 89
- D . 123
- E . 255
Segment
- A . 3, 4, 2, 1
- B . 4, 3, 1, 2
- C . 3, 2, 4, 1
- D . 1, 2, 4, 3
A network administrator is responsible for maintaining a large number of HPE Aruba Networking CX switches. As a best practice, they regularly update the switch firmware. The administrator has downloaded a new firmware image, `FL.10.09.1020.swi`, to a TFTP server. The goal is to update the secondary image partition on a switch without interrupting the currently running primary image.
Which set of commands will achieve this administrative task? (Select all that apply.)
- A . `copy tftp://192.168.1.100/FL.10.09.1020.swi primary`
- B . `boot system secondary`
- C . `copy tftp://192.168.1.100/FL.10.09.1020.swi secondary`
- D . `show images`
- E . `write memory`
A Network Operator is examining the MAC address table of a switch to troubleshoot a connectivity issue.
show mac-address-table vlan 10
MAC Address Port Type
— –
00:50:56:8d:1a:2b 1/1/1 Dynamic
00:50:56:8d:3c:4d 1/1/1 Dynamic
00:50:56:8d:5e:6f 1/1/2 Dynamic
How does a Layer 2 switch build this table?
- A . By receiving broadcast announcements from a central MAC address server.
- B . By inspecting the destination MAC address of incoming frames.
- C . By inspecting the source MAC address of incoming frames.
- D . By downloading the table from the default gateway via ARP.
What is the administrative distance of a directly connected route?
- A . 0
- B . 1
- C . 90
- D . 100