Practice Free D-PE-OE-01 Exam Online Questions
How can a system administrator compare the currently installed hardware to the original system configuration?
- A . Pull a SupportAssist Collection Comparison Report
- B . Restore the original System Profile
- C . View Factory Shipped Inventory
- D . Export a Tech Support Report
A drive has failed in one of the two disk groups in a Dell PowerEdge server. The assigned hot spare did not replace the failed drive.
How should the RAID SET have been assigned to avoid this issue?
- A . Persistent hot spare
- B . Global hot spare
- C . Revertible hot spare
- D . Dedicated hot spare
A drive has failed in one of the two disk groups in a Dell PowerEdge server. The assigned hot spare did not replace the failed drive.
How should the RAID SET have been assigned to avoid this issue?
- A . Persistent hot spare
- B . Global hot spare
- C . Revertible hot spare
- D . Dedicated hot spare
Which Dell PowerEdge server model is best suited to run complex high-performance AI applications?
- A . R760
- B . XE9640
- C . XR12
- D . MX760c
A server arrives without any RAID configuration. All firmware is up to date. The server has a PERC H730p controller. The technician needs to configure the required RAID arrays prior to OS installation.
Which three methods can be used to configure the RAID arrays? (Choose three.)
- A . Boot into the Ctrl+C
- B . Access the Physical Disk section of the iDRAC GUI
- C . Access the Virtual Disk section of the iDRAC GUI
- D . Boot into the Ctrl+R
- E . Boot into the F2 BIOS
A technician replaces a failed power supply unit (PSU) on a server. The LED on the new PSU blinks green and turns off.
What is the state of the new PSU?
- A . Successfully added and functional
- B . Successfully added and in standby mode
- C . Mismatched
- D . Defective
Which is a feature of SNAP I/O?
- A . Bypasses UPI and directly connects to both CPU sockets
- B . Does not use a PCIe slot
- C . Lower network throughput
- D . Higher latency
A Dell EMC PowerEdge 14G server fails to boot, and the server administrator is investigating the cause of the failure. The following event appears in the Lifecycle Log: “The Boot Guard detected a corrupted BIOS in the server”.
What caused the boot failure?
- A . Motherboard faulty
- B . Server compromised
- C . Boot Guard
- D . Incorrect BIOS
A technician working with a Dell EMC PowerEdge 1 take corrective action?
- A . Check the System Event Log
Check PSU LED
Reseat the PSU - B . Check the System Event Log
Check PSU LED
Do a virtual reseat of the iDRAC - C . Check the LCC Log
Check PSU LED
Reseat the CPU - D . Check the LCC Log
Check PSU LED
Reseat the PSU
A technician is changing the iDRAC IP address from the static IP address 10.37.125.88 to DHCP on the technician’s PowerEdge R640 that does not have a front LCD. After completing this task, they are unable to determine which IP address was given to the iDRAC and they cannot reboot the server.
What method could the technician use to determine what IP address is assigned to the iDRAC?
- A . Use the iDRAC Direct feature. Access iDRAC web GUI and determine the assigned IP address
- B . Plug a monitor or KVM into the system. Reboot the server to view the assigned IP iDRAC address on the Dell boot up splash screen
- C . Log in to the Lifecycle and check the iDRAC Settings.
- D . Hold the system identification button down for more than 3 seconds to reset it back to the default static address 192.168.0.120