Practice Free 350-401 Exam Online Questions
Which feature allows HSRP to failover from the active route processor to the standby route processor without loss of data or path change?
- A . preemption
- B . IP SLA tracking
- C . stateful switchover
- D . HSRP tracking
Which next generation firewall feature supports separate security services for multiple departments?
- A . state sharing mode to .trade the user data sessions and replication to the neighbor firewall using a failover link
- B . Layer 3 mode with resource tracking capabilities and automatic configuration synchronization between the nodes and security zones
- C . multicontext mode with specific logical or physical interface allocation within each context and grouped into security zones
- D . virtual switch mode to provide traffic inspection capabilities for the flows entering the firewall and dropping packets based on policy configuration
Which function does a Cisco SD-Access extended node perform?
- A . in charge of establishing Layer 3 adjacencies with nonfabric unmanaged node
- B . performs tunnelling between fabric and nonfabric devices to route traffic over unknown networks
- C . provides fabric extension to nonfabric devices through remote registration and configuration
- D . used to extend the fabric connecting to downstream nonfabric enabled Layer 2 switches
SIMULATION 2:
Copy run start
Copy run start
Copy run start
Verification:
OR
Which protocol is used by vmanage to push centralized policies to vsmart controllers?
- A . NETCONF
- B . TLS
- C . STUN
- D . OMP
SIMULATION 20:
R30
Config t
router ospf 10
router-id 10.0.1.30
int ran lo0 , e0/0-1
ip ospf 10 a 0
exit
int et0/2
ip ospf 10 a 50
exit
router ospf 10
area 50 range 10.10.0.0 255.255.128.0
area 50 range 10.50.0.0 255.255.128.0
end
Which First Hop Redundancy Protocol should be used to meet a design requirements for more efficient default bandwidth usage across multiple devices?
- A . GLBP
- B . LCAP
- C . HSRP
- D . VRRP
A client device roams between wireless LAN controllers that are mobility peers, Both controllers have dynamic interface on the same client VLAN which type of roam is described?
- A . intra-VLAN
- B . inter-controller
- C . intra-controller
- D . inter-subnet
Refer to the exhibit.
How should the script be completed so that each device configuration is saved into a JSON-formatted file under the device name?
A)
B)
C)
D)
- A . Option A
- B . Option B
- C . Option C
- D . Option D
Which feature is needed to maintain the IP address of a client when an inter-controller Layer 3 roam is performed between two WLCs that are using different mobility groups?
- A . interface groups
- B . RF groups
- C . AAA override
- D . auto anchor