Practice Free 350-501 Exam Online Questions
Refer to the exhibit. An engineer is scripting ACLs to handle traffic on the given network. The engineer must block users on the network between R1 and R2 from leaving the network through R5, but these users must still be able to access all resources within the administrative domain.
How must the engineer implement the ACL configuration?
- A . Con gure a permit any ACL on the R1 interface to R2 in the egress direction, and a deny any ACL on the interface in the ingress direction
Refer to the exhibit. A network engineer is trying to retrieve SNMP MIBs with RESTCONF on the Cisco switch but fails. End-to-end routing is in place.
Which configuration must the engineer implement on the switch to complete the task?
- A . snmp-server community public RO
- B . snmp-server community cisco RW
- C . netconf-yang cisco-ia snmp-community-string Public
- D . netconf-yang cisco-ia snmp-community-string Private
B
Reference: https://www.cisco.com/c/en/us/support/docs/storage-networking/management/200933-YANG-NETCONF-Con guration-Validation.html
What causes multicast tra
c to permanently stay on the shared tree and not switch to the source tree?
- A . SSM range is being used
- B . The RP announcements are being
ltered
- C . The SPT threshold is set to in nity
- D . The RP IP address is configured incorrectly
Refer to the exhibit. Router 4 is added to the network and must be in the same area as router 1.
Which NET should the engineer assign?
- A . 49.0111.0000.0000.0001.00
- B . 49.0001.0000.0000.0004.00
- C . 49.0011.0000.0000.0002.00
- D . 49.0011.0000.0000.0003.00
How much must the MTU be increased when configuring the 802.1q VLAN tag?
- A . 2 bytes
- B . 4 bytes
- C . 8 bytes
- D . 12 bytes
B
Reference: https://www.cisco.com/c/en/us/support/docs/lan-switching/8021q/17056-741-4.html
Which configuration modifies Local Packet Transport Services hardware policies?
- A .
- B .
- C .
- D .
Con gure IS-IS route redistribution for all static routes and connected interfaces on R1, R2, and R3.
Which action does the ingress VTEP perform on tra
c between EVPN VXLAN overlays?
- A . routing and bridging when doing asymmetric IRB
- B . bridging when doing symmetric IRB
- C . routing and tunneling when doing symmetric IRB
- D . routing when doing asymmetric IRB
A
Reference: https://www.cisco.com/c/en/us/products/collateral/switches/nexus-9000-series-switches/guide-c07-734107.html
Which action does the ingress VTEP perform on tra
c between EVPN VXLAN overlays?
- A . routing and bridging when doing asymmetric IRB
- B . bridging when doing symmetric IRB
- C . routing and tunneling when doing symmetric IRB
- D . routing when doing asymmetric IRB
A
Reference: https://www.cisco.com/c/en/us/products/collateral/switches/nexus-9000-series-switches/guide-c07-734107.html
Refer to the exhibit. Tier 2 ISP A on AS 653 is connected to two Tier 1 ISPs on AS 321 and AS 51 respectively. The network architect at ISP A is planning traffic ow inside the network to provide predictable network services. Cisco Express Forwarding is disabled on the edge router.
How should the architect implement
BGP to direct all traffic via the Tier 1 ISP with next-hop 7.4.5.2?
- A . Implement the BGP routing protocol and run the bgp deterministic-med command.
- B . Implement MP-BGP with a 4-byte AS number with the bgp best path compare-routerid command.
- C . Implement the BGP routing protocol and the maximum-paths 2 configuration.
- D . Implement BGP route-re ector functionality with the bgp always-compare-med configuration.